Bolt X Quick Start Guide
67
connected to the external E-Stop box, but if no external E-Stop is
needed, a bypass jumper may be used.
9. CAN connector is used to communicate with external CAN capable
motor drives.
10,11. ZOOM, FOCUS connectors for external servo Lens Control Motors
(LCMs) mounted on the camera platform. For pin-out information
see Servo motor connector on page 68.
12. TILT connector for a Tilt servo motor on a head. For pin-out
information see Servo motor connector on page 68.
13,14. AUX-1, AUX-2 connectors for control of auxiliary servo motors.
For pin-out information see Servo motor connector on page 68.
To Next Page
Loading...