Appendix
The data in this manual are not binding and may be changed by the manufacturer without notice. Reproduction of this manual, even partial, is strictly prohibited.
UNIT RUNNING CHECKLIST
Start
No
Remove all unauthorised persons from the test area
Power on the unit.
Enter the menu: “Manual Procedure”
Contactors and devices functioning correctly?
From the “Manual Procedure” menu: activate the
various loads in sequence
Power off the unit
Reset thermal-magnetic cutouts or replace
compressor fuses
Power on the unit
Start the unit from the control panel
(ON/OFF button)
The START-UP procedure has now been
completed
All On/Off operations must be performed exclusively
using the On/Off pushbutton located on the control
panel
Check the component and renew if necessary
Yes
To Previous Page