OPERATING AND MAINTENANCE MANUAL
Chapter 7 - Electronic controller
TAEevo Tech 015÷802 60 Hz UL
63
The data in this manual are not binding and they can be modified by the manufacturer without notice. Reproduction of this manual is strictly prohibited
EN
ENGLISH
• load / function status as showed below:
7.23 Function of buttons
Meaning of the keys:
In case of alarm the pressure of any key silences the alarm.
7.24 Probes visualization
7.25 Unit start/stop
Compressor/s
(blinking during the start up
delay)
Economy function or Energy Saving
/
Water pump / Supply fan Unloading function
Condenser fan or Condensing
valves
Economy or ON/OFF by timetable (Function not
available)
Electric heater Defrost (Function not available)
Sanitary water (Function not
available)
Alarm
Allows to read the value of the
probes configured in the Ichill
Allows to read/modify the set point
Allows to switch on the Ichill in
cooling mode
Allows to read the alarms
Allows to switch on the Ichill in
heating or cooling mode
(Function not available)
Allows to enter the SERVICE menù
Allows to put the Ichill in STD-
BY (active when the machine is
in cooling mode)
Allows to read the main information of the
circuits (compressor status, water pump status,
pressure probe value,…)
Mask Description
Press key to visualize the value of the probes configured in the
control (press or to visualize all the probes).
Mask Description
The unit can be switched on and off as follows:
• From the keypad
• From a digital input configured as remote ON/OFF
To Next Page
Loading...