MTA TAEevo Tech 101 - Chapter 9 OPERATION and MAINTENANCE; Operation; Maintenance; Access to the Unit

OPERATING AND MAINTENANCE MANUAL
Chapter 9 - Operation and maintenance
TAEevo Tech 015÷802 60 Hz UL
184
The data in this manual are not binding and they can be modified by the manufacturer without notice. Reproduction of this manual is strictly prohibited
ENGLISH
EN
CHAPTER 9
OPERATION AND MAINTENANCE
9.1 Operation
Operation of the unit is fully automatic.
It is not necessary to power the unit off in the absence of a thermal load because it powers off automatically once it reaches
the preset water outlet temperature.
9.2 Maintenance
ATTENTION
Before installing or operating these units, ensure that all personnel involved have read and understood Chapter 2
“Safety”
9.3 Access to the unit
ATTENTION
Any task that requires the panelling to be opened must be performed only with the unit powered off and disconnected
from the electrical supply.
For models TAEevo Tech 015÷051:
To access the refrigerant circuit components use the wrench supplied with the unit and open the latches securing front
panel (A).
To access the evaporator and hydraulic circuit components use a screwdriver to undo the screws fixing panel (B).
To access the electrical circuit components remove front panel (C).
For models TAEevo Tech 081÷802:
To access the components of the refrigerant circuit open the latches securing panel (A). You can also access the refrigerant
circuit components by removing the side panels (B). Access to the evaporator and the hydraulic circuit components is
possible by removing rear panel (F) or side panels (D), (E).
TAEevo Tech 015÷020 TAEevo Tech 031÷051 TAEevo Tech 081÷161
TAEevo Tech 201÷351 TAEevo Tech 381÷401
C
A
B
C
A
B
B
B
A
C
F
B
B
C
F
D
A
E
B
B
CF
D
A