MTA TAEevo Tech 101 - Compressor Maintenance; Water Pump Maintenance

OPERATING AND MAINTENANCE MANUAL
Chapter 7 - Electronic controller
TAEevo Tech 015÷802 60 Hz UL
66
The data in this manual are not binding and they can be modified by the manufacturer without notice. Reproduction of this manual is strictly prohibited
ENGLISH
EN
7.30 Compressor maintenance
Pressing it is possible to visualize the compressor working hour and the number of activations.
It is also possible to disable the compressor for maintenance.
Pressing in correspondence of the circuit 1 or circuit 2 allows access to the compressors of the circuit.
7.31 Water pump maintenance
Mask Description
Pressing or it is possible to select the group of
parameters to modify, then press .
How to modify the value of the parameter:
• press or to select the parameter to
modify
• press
• press or to modify the value
• press to confirm.
Press or to scroll the parameters.
Mask Description
How to reset the working hours and number of start up:
• press or to select the label RST;
• press for 5 seconds to reset hour and start up.
How to disable a compressor:
• press or to select the status of the
compressor (Enabled in the "Status" column);
• press for 5 seconds
• press or to select the status "Disabled"
• press for 5 seconds to confirm the operation.
Mask Description
How to reset the working hours:
• press or to select the label RST;
• press for 5 seconds to reset hour and start up.