MTA TAEevo Tech 101 - Thermoregulation Parameters

OPERATING AND MAINTENANCE MANUAL
Chapter 7 - Electronic controller
TAEevo Tech 015÷802 60 Hz UL
73
The data in this manual are not binding and they can be modified by the manufacturer without notice. Reproduction of this manual is strictly prohibited
EN
ENGLISH
7.41 Parameters description-settings
The following is a list of all the programmable parameters complete with their associated access levels.
U= User level
S= Service level
C= Manufacturer level
ATTENTION
Ensure these instructions are observed in full to avoid incorrect operation of the unit.
7.41.1 Description of parameters
Parameter Level Description Min. Max. UM Resolution
Thermoregulator
ST01 U Chiller setpoint.
Enables setting of the working setpoint in chiller mode.
ST02 ST03 °C
°F
Dec
Int
ST02 U Chiller minimum set.
Establishes the minimum limit that can be utilised to set the
chiller working setpoint.
-50.0
-58
ST01 °C
°F
Dec
Int
ST03 C Chiller maximum set.
Establishes the maximum limit that can be utilised to set the
chiller working setpoint.
ST01 110.0
230
°C
°F
Dec
Int
ST04 C Heat pump setpoint.
Enables setting of the working setpoint in heat pump mode.
ST05 ST06 °C
°F
Dec
Int
ST05 C Heat pump minimum set.
Establishes the minimum limit that can be utilised to set the heat
pump working setpoint.
-50.0
-58
ST04 °C
°F
Dec
Int
ST06 C Heat pump maximum set.
Establishes the maximum limit that can be utilised to set the heat
pump working setpoint.
ST04 110.0
230
°C
°F
Dec
Int
ST07 U Control steps activation band in chiller mode. 0.1
0
25.0
45
°C
°F
Dec
Int
ST08 C Control steps activation band in heat pump mode. 0.1
0
25.0
45
°C
°F
Dec
Int
ST09 C Defines the probe for temperature control of the unit in chiller
mode:
0= Evaporator inlet NTC temperature probe
1= Evaporator outlet NTC temperature probe no. 1
2= Evaporator outlet NTC temperature probe no. 2
3= Common evaporator outlet NTC temperature probe
4= Remote terminal temperature probe no. 1
5= Remote terminal temperature probe no. 2
05