5.4.5 MULTIMODE (U/S) SOFT-KEYS 1, 2, 3
The Multimode soft-keys are used as Phaco Mode presets for quick access to user- programmed
Phaco Modes. The user can select any of the three (3) multimode soft-keys and edit default Phaco
programs by completing the following steps:
5.4.5.1 Select any multimode soft-key.
5.4.5.2 Select any of the Phaco Tabs: Normal, Burst, or Micro.
5.4.5.3 Edit any of the following Phaco parameters for the Phaco Tab selected:
Normal Tab Burst Tab Micro Tab
U/S Power (%) U/S Power (%) U/S Power (%)
Pulse (pulses/s) Burst (% - ms) Burst On / Off (ms)
Flow (cc/min.) Flow (cc/min.) Flow (cc/min.)
Vacuum (mmHg) Vacuum (mmHg) Vacuum (mmHg)
Fixed Single Fixed
Linear Multi Linear
Bottle Height Bottle Height Bottle Height
5.4.5.4 Select another multimode soft-key.
5.4.5.5 Select another Phaco Tab and edit any of the Phaco parameters.
5.4.5.6 Now select the first multimode soft-key you previously edited. The edited Phaco
parameters should be as first edited.
NOTE: The edited Phaco parameters will remain as edited until the system is
powered OFF.
The Phaco parameters will return to the default factory settings when the system is powered ON.
To Next Page
Loading...