11.0 SYSTEM PERFORMANCE (continued)
Figure 11-3 shows the power output levels versus impedance at full power & 50% power.
11.1 EMC REQUIREMENTS FOR THE MODEL 3000
The Model 3000 Phacoemulsification System (Model 3000) meets all applicable requirements of
IEC/EN 60601-1-2 for electromagnetic compatibility. The Model 3000 needs special precautions
regarding EMC and needs to be installed and put into service according to the EMC information
provided in this section of the manual.
Portable and mobile RF communications equipment can affect the operation of the Model 3000.
The use of this equipment adjacent to or stacked with other equipment should be avoided because
it could result improper operation. If such use is necessary, this equipment and the other
equipment should be observed to verify that they are operating properly.
The following is a list of cables and other accessories that are used as part of the COMPLETE
Model 3000
package and comply with sections 36.201 and 36.202 of the EMC Standard
IEC60601-1-2 (E):
Power cord 17031-S2-8 18/3 SJT / NEMA 5-15P 96 inch
U/S Handpiece 01-899145 3xAWG26 / DIN 9p 81 inch
01-899530 3xAWG24 / DIN 9p 81 inch
Footpedal 553-0006-001 5xAWG28 / DIN 12p 120 inch
Cart cord 551-0032-001 5xAWG22 / DIN 6p 16 inch
Use of cables or accessories other than those specified, with the exception of cables and
accessories sold by the manufacturer of the Model 3000 as replacement parts for internal
components, may result in increased EMISSIONS or decreased IMMUNITY of the Model 3000.
To Next Page
Loading...