5.9.5 CHANGE SAVED PROGRAM SETTINGS WITHOUT CHANGING THE PROGRAM NAME
5.9.5.1 Press the “PROGRAM” soft-key at the top of the screen, to the right of the word
FACTORY.
5.9.5.2 Press the “Program Name” you would like to change the settings on.
5.9.5.3 Go though each Mode and change the desired parameter settings in each mode
(U/S, I/A, VIT, COAG), except the IRRIGATION (IRR) MODE, using the UP and
DOWN arrow soft-keys and Mode function keys.
5.9.5.4 After all desired parameter settings and Mode functions have been changed, press
the “OPTIONS” soft-key.
5.9.5.5 Press the “Programs” tab.
5.9.5.6 Press the “Update” function soft-key.
5.9.5.7 Press the “OK” function soft-key to save the program changes, or press “Cancel” to
exit and not save the program changes.
5.9.5.8 The Program name remains the same with or without the changes.
5.9.6 DELETE PROGRAM NAMES
5.9.6.1 Press the “PROGRAM” soft-key at the top of the screen, to the right of the word
FACTORY.
5.9.6.2 Press the “Program Name” you would like to delete.
5.9.6.3 Press the “OPTIONS” soft-key.
5.9.6.4 Press the “Programs” tab.
5.9.6.5 Press the “Delete” function soft-key.
5.9.6.6 Press the “OK” function soft-key to delete the program name, or press “Cancel” to exit
and not delete the program name.
NOTE: The settings of the deleted program name will remain on the system.
Re-save the program per Section 5.9.2 Create and Save a Custom Program or select the
FACTORY program to return the system to the Factory default settings.
To Next Page
Loading...