MTP 3000 - Accessory Setup Instructions

Page 60 of 90
6.2 ACCESSORY SETUP
Complete the following instructions prior to using the listed accessories to the Model 3000.
WARNING: The following components must be sterilized prior to their use.
6.2.1 IRRIGATION / ASPIRATION HANDPIECE
6.2.1.1 Install the aspiration tip onto the I/A Handpiece using the supplied tip wrench,
tighten until fully seated.
CAUTION: DO NOT over-tighten or thread damage to the handpiece may occur.
6.2.1.2 Carefully attach threaded irrigation sleeve over I/A tip, exposing desired amount of tip,
with the irrigation ports on the tip sleeve in line with the aspiration tip port.