Switch
Switch for deactivating the mixer. Without the switch the mixer is switched on.
All three components Source, Target, and Switch can be selected by
operating a switch, using the central wheel or pressing the + or - button.
Press the REV/CLR button to erase Source and Target. The Switch is
inverted when pressing the button the first time and erased when the button is
pressed again. Pressing the button a third time restores the original setting.
Zero point
Possible values:
Source with centred zero point, to Target with centred zero
point.
Each side can be configured separately using Travel+ and
Travel-.
Source with centred zero point, to Target with zero point
located at one end of the associated control. The zero point was
defined during controls assignment.
Each side can be configured separately using Travel+ and
Travel-.
Source with zero point located at one end of the associated
control. The zero point was defined during controls assignment.
The Target has a centred zero point.
The mixing level is configured using Travel+. Travel- has no
effect.
Source with zero point located at one end of the associated
control to a Target of the same type. The zero points were
defined during controls assignment.
The mixing level is configured using Travel+. Travel- has no
effect.
To Next Page
Loading...
Need help?
General
