If moisture accumulates in electrical devices, immediately stop using the device,
disconnect it from the power supply and allow it to dry in the open state as far as
possible (up to a few days). Thereafter, perform a careful functional test. In case of
major condensation, have the device inspected at an authorised MULTIPLEX
Service Centre (see section 1.2 "Contact" on page 9).
Caution: static electrical charges!
In extremely dry air static charges tend to build up in the transmitter and / or the
pilot. The discharge takes the form of static sparking which can cause interference
or damage to the transmitter and other components of the radio control system.
Operation of the radio control system is allowed without restrictions within EU
territory and Switzerland.
Program a new model at home in peace. Make sure that the power system of the
model cannot start up unexpectedly. Check all functions carefully. Completely
familiarize yourself with the operation of the transmitter before putting the model
in operation.
To Next Page
Loading...
Need help?
General
