Operating the transmitter
Controls mode
Ailerons, elevators and rudders are controlled by the stick units. The stick units are
assigned to the individual axes using the standardised controls mode (1 to 4).
You configure the controls mode in the Setup > Assign.Controls > Ctrl Mode
menu (see section 5.3.5 "Assign.Controls" on page 101). One vertical axis always
remains unassigned (¢ icon) and can be assigned using the assignment list. In
power models, ¢ is typically used for "Throttle", in glider-type models for "Spoiler".
The controls modes:
To Next Page
Loading...
