Multiplex PROFI TX 9

Creating and customising models
PROFI TX
Page 189
 Other control functions:
If required, assign other control functions to unused servo channels in the
Servo > Assignment menu (see section 5.6.2 "Assignment" on page 142).
 V-TAIL+:
In the Servo > Assignment menu, reassign servo channels 2 and 3 from
ELEVATOR+ / Rudder to V-TAIL+.
Then, adjust the rotation direction and travels in the Mixer > V-TAIL+ menu
(see section 5.5.2.4 "Mixers on the servo side" on page 137).
 Flight phases:
Assign a switch to flight phases 1 to 3 in the Setup > Assign.Switches
menu.
The 4th phase is activated by a assigning a switch to Phase 4.
Choose a suitable name for each flight phase in the Setup > Flight phases
menu. Set the transition time to the next phase using the Slow parameter
(see section 5.3.2 "Flight phases" on page 94).
 Flight phases as virtual switches:
You can also assign flight phases as virtual switches, e.g. if you prefer to use
different mixers in some flight phases.
 Control functions:
Further options—many of which are flight phase specific—are available in the
ControlFunctions menu (see section 5.4 "ControlFunction" on page 112).