Multiplex PROFI TX 9 User Manual

Menus
Page 88
PROFI TX
4
Current time
Flashing warnings and notifications in capital letters. Warnings contain an
exclamation mark.
MEMORY ERROR!
Displayed when errors occur while loading
a model memory (page 159).
RANGE!
Transmitting power is reduced for the range
check (page 93).
RF ERROR!
The RF component is defective.
STUDENT MODE!
The Student mode is enabled.
STUDENT
Only in Teacher mode: The selected control
functions are transferred to the student.
MULTIFLIGHT
A MULTIFlight stick was detected: The mixers
on the servo side are switched off.
5
Sensors
Values for sensor addresses 0, 1, and 15 if a receiver with downlink is
used. The value is shown crossed out if no sensor signal is received for
several seconds.
If the sensor reports an alarm:
 The sensor value starts to flash.
 The appropriate warning light for the sensor group below the screen
starts to flash (see section 3.1.1 "Top view" on page 23).
 The device also starts to vibrate if the vibration alarm is activated
(see section 5.3.4.2 "Vibra.Alarm" on page 100).
If the sensor clears the alarm the displayed value stops flashing. The
vibration alarm and warning light remain active until they are cleared by
pressing the ENTER button.
Notice: In other status displays the ENTER button has different functions.
6
Trim display
Trim settings for the 4 stick axes. The trim display can be customised
in the Setup > Transmitter menu.

Multiplex PROFI TX 9 Specifications

General

Brand	Multiplex
Model	PROFI TX 9
Category	Remote Control
Language	English