Murr Elektronik Mico Pro Series - For your safety; General safety instructions; Qualified personnel (target group); Intended purpose

For your safety
User manual 9000-41011-0200000_hdb_en_20 13 / 92
2 For your safety
Safety for you and peo-
ple around you!
 Read this chapter carefully.
 Only then can you work with the device.
Use of the device  Comply with all safety and accident prevention regulations when conduct-
ing project engineering, installation, startup, operation, and testing of the
device.
 Check material resistance if aggressive media are used.
NOTE
Interventions in the hardware and software of the device dare, if they are not
described in this document, only be carried out by qualified personnel from
Murrelektronik GmbH.
NOTE
The operating instructions must be always available to the operator of the ma-
chine where the device is used.
2.1 General safety instructions
Note:
 the relevant safety and accident prevention regulations
 the EU Directives which apply to your application or national regulations
 generally recognized safety rules
2.2 Qualified personnel (target group)
The Mico Pro system may only be mounted, put into operation and operated
by qualified personnel.
Personnel is considered qualified if they meet the following requirements:
 The personnel have undergone appropriate technical training.
 Have been trained for the operation of the machine/system as well as the
relevant safety regulations.
 Have access to the manual and the other applicable documents
(see 1.3.2 "Applicable documents").
 Are familiar with the safety standards which are common practice in auto-
mation engineering.
2.3 Intended purpose
The power supply unit is designed and manufactured for:
 Industrial use.
 Operation within the specified environmental conditions.
 Installation in a control cabinet.
2.4 Foreseeable misuse
Avoid misuse!  Operate the Mico Pro system only in technically perfect condition.
 Ensure that only qualified and authorized personnel works with/on the sys-
tem.