Configuration
Operator’s Manual V1.1 • EasyOne Air • EasyOne Connect
© ndd Medizintechnik AG • Technoparkstrasse 1, 8005 Zurich, Switzerland • www.ndd.ch 102/144
117
3 Close and lock the battery compartment by turning the lock screw
counterclockwise.
4 Choose > .
The firmware update that is on the SD memory card is displayed.
5 Select the firmware update from the SD memory card.
The firmware update is performed.
After the firmware update, a message is displayed whether the update
was successful, and EasyOne Air restarts.
6 Remove the SD memory card.
11.1.3 Performing a backup of EasyOne Air
>
Required material
• An SD memory card with at least 2 GB of free space
To archive a copy of the complete database (including patient data and
results) and of the configuration settings, perform backups regularly. You can
also use the backup to set up another EasyOne Air with the same database
and configuration settings.
For each backup, the manufacturer recommends to use one SD memory card
with 2 GB storage capacity.
1 Unlock and open the battery compartment by turning the lock screw
clockwise.
To Next Page
Loading...
Need help?
General
