Configuration
Operator’s Manual V1.1 • EasyOne Air • EasyOne Connect
© ndd Medizintechnik AG • Technoparkstrasse 1, 8005 Zurich, Switzerland • www.ndd.ch 108/144
117
Curve Overlay
To select which trials are to be displayed in the flow-volume curve and the
volume-time curve on the test result screens, choose the corresponding
check box.
By default, + Session Best and + Pre Best are selected.
Test Procedure
If you deselect Manual Test Stop, you enable automatic test stop.
By default, Manual Test Stop is selected.
General
To display on the test result screens a comparison of the best trial and the
predicted values as percentage values also for the post, choose Show %
predicted column for post tests.
To display ratio parameters (for example FEV
1
/FVC) as a percentage (for
example 78%) instead of a decimal ratio (for example 0.78), choose Show
ratio parameter in %.
By default, both check boxes are deselected.
To set the maximum number of trials for forced and slow spirometry enter a
value between 1 and 99 in the text field Max Number of Trials Forced/Slow.
The default value is 99. The text fields DLCO and MBW do not apply to the
EasyOne Connect PC software, but to the firmware of EasyOne Pro/LAB only. A
change of the values DLCO and MBW is without effect for the EasyOne Connect
PC software.
11.2.4.2 Utilities > Configuration > Test > Predicted
Predicted normal values setting
Predicted normal values are based on the latest scientific publications.
Therefore, the predicted normal values are subject to change. These changes
are delivered to you via software updates.
Updated information is published in an Application Note on the ndd website.
Application Note Reference Predicted Normal Values
Application Notes for further information, 3
List of bibliographic references, 132
To Next Page
Loading...
Need help?
General
