Configuration
Operator’s Manual V1.1 • EasyOne Air • EasyOne Connect
© ndd Medizintechnik AG • Technoparkstrasse 1, 8005 Zurich, Switzerland • www.ndd.ch 116/144
117
XML Export
If you do not require curve data or trial values in exported XML, you can
exclude this data by deselecting the check boxes.
By default, these check boxes are selected.
11.2.7 Loading and selecting a custom report layout of EasyOne Connect
You can load custom report layouts according to your requirements. For easy
identification you can rename the report layouts. Your EasyOne Air dealer or
the ndd Servicing Department can assist you in creating a custom report
layout.
Prerequisite
You have created or received a report layout file with an *.repx file
extension.
You have connected the drive with the report layout file, or you have
copied the report layout file to PC that runs EasyOne Connect.
If you want to rename the report layout, you only need to rename the REPX file.
The name of the report layout file is printed on every report.
To load the report layout file
1 Choose Utilities > Configuration > Report.
2 Choose Load.
3 Navigate to the report layout file, select the file, and choose Open.
4 Read and confirm the warning message about custom report layouts.
To select your custom report layout
1 From any result screen, choose Report.
2 From the Layout Selection drop-down list on the top left, choose your
custom report layout.
11.2.8 Description of printer configurations of EasyOne Connect
Utilities > Configuration > Printer
From the drop-down list, choose a printer. To be displayed in the drop-down
list, the printer must be installed in Microsoft Windows.
With the Refresh button, you can refresh the drop-down list after you have
installed a new printer in Microsoft Windows.
With the System Default button, you choose the printer that is set as the
default printer in Microsoft Windows.
About compatible printers, 19
To Next Page
Loading...
Need help?
General
