Performing spirometry
Operator’s Manual V1.1 • EasyOne Air • EasyOne Connect
© ndd Medizintechnik AG • Technoparkstrasse 1, 8005 Zurich, Switzerland • www.ndd.ch 55/144
74
7.5.2 Choosing a test and selecting an existing patient
If you test a patient that you have tested before or if you have transferred
patient data onto EasyOne Air from EasyOne Connect on your PC, start by
selecting an existing patient.
Prerequisites
Previously, you have manually added the patient to EasyOne Air.
Or, you have transfered patient data onto EasyOne Air from
EasyOne Connect on your PC.
Working with patient data and reports on EasyOne Air, 82
Copying patient data between EasyOne Air and EasyOne Connect, 88
1 If you want to perform an FVC test, choose .
The patient selection list is displayed.
2 If you want to perform any other test, do the following:
a) Choose .
b) Choose one of the test icons.
The patient selection list is displayed.
3 Select a patient.
If the patient has performed a test within the previous 24 hours, the
question window is displayed. Proceed with step 4.
If the patient has not performed a test before or not within the previous
24 hours, the summary screen is displayed. Step 4 does not apply.
4 If the question window is displayed, do one of the following:
a) To add a trial to the existing test, choose Add Trial.
b) To add a post to the existing test after adminstering a bronchodilator,
choose Add Post.
c) To create a new test that is unrelated to the existing test, choose Create
new.
The summary screen is displayed.
About the summary screen, 56
Performing a complete test using EasyOne Air stand-alone, 57
?
To Next Page
Loading...
Need help?
General
