NEC MH240 - PRECAUTION

11
• HOW TO CHARGE THE BATTERY
Be sure to charge the battery before using the phone for the first time. Use one of the following:
● Cradle
● AC Adapter (direct connection)
Note: The empty battery can be fully charged in about 4 hours.
Note: Even if the phone is not used for a long period of time, charge the battery biannually at least
because it is discharged little by little spontaneously. If the battery is discharged too much, it
will be deteriorated and might be unavailable for the recharge.
By using the Cradle:
The phone can be charged by using the cradle. You can also charge the battery by inserting the battery
pack alone in the slot on the cradle. This is useful when you have a spare battery.
(1) Insert the AC adapter plug (mini USB) into the USB connector in the back of the cradle.
(2) Plug in the AC adapter into an appropriate AC outlet.
(3) Place the phone and/or the spare battery pack as shown above. When placing a battery pack into
the slot, insert it so that the label faces downward.
(4) The LED on the cradle lights red, indicating the battery is being charged. When the phone battery
is not being charged the Info LED turns off.
(5) The LED on the cradle lights green when the spare battery is fully charged. After this, charging to
the phone battery will start and the Info LED lights red.
(6) The Info LED lights green when the phone battery is fully charged.
Note: If any abnormality is found to the battery, the LED on the cradle lights off.
AC outlet
AC Adapter
AC adapter plug
Spare Battery (optional)
Info LED
Indicate charge status
Cradle (Battery Charger)
USB connector