NEC MH240 - BASIC OPERATION; TO POWER ON THE PHONE (STANDBY MODE)

23
Set the Security (WEP):
Factory Default: WPA2-PSK (1.NEC-SETUP), OPEN (2 to 9)
STEP1: Go to “Config” menu. (See “PLACE THE PHONE IN CONFIG MODE”)
STEP2: Press to view Profile Select menu.
STEP3: Press key to select a profile you want to set security and then press “OK” soft key.
STEP4: Press to go to Security setting screen.
STEP5: Press key to select “WEP” and then press key.
STEP6: Press to go to Key Index setting screen.
STEP7: Press key to select a Key Index and then press “OK” soft key.
STEP8: Press to go to WEP Key edit screen.
STEP9: Edit WEP Key (HEX or ASCII) and then press “OK” soft key.
STEP10: Press to save.
Prof. Select
Delete OK Back
1.NEC-SETUP
2.<Profile2>
3.<Profile3>
4.<Profile4>
Security
WPA
OPEN
WEP
WPA-PSK
WPA2-PSK
Key Index
OK Back
1.Index 1
2.Index 2
3.Index 3
4.Index 4
Key
abcdefghij123
12 OK Clear