NEC MH240 - GETTING STARTED; HOW TO INSERT THE BATTERY

19
• NETWORK SETTINGS
This section explains the wireless and network data for the phone. The following items are covered
here.
• Set the Profile Name
• Set the ESSID (Manual)
• Set the ESSID (AP Scan)
• Set the Security (OPEN)
• Set the Security (WEP)
• Set the Security (WPA-PSK)
• Set the Security (WPA2-PSK)
• Set the Security (WPA: PEAP)
• Set the Security (WPA: TLS)
• Set the Security (WPA2: PEAP)
• Set the Security (WPA2: TLS)
• Set the DHCP (IP)
• Set the IP Address (Required when Selecting Fixed IP)
• Set the Net Mask (Required when Selecting Fixed IP)
• Set the Gateway (Required when Selecting Fixed IP)
• Set the DNS Primary (Required when Selecting Fixed IP)
• Set the DNS Secondary (Required when Selecting Fixed IP)
• Set the SIP Profile
• Set the Hand-off List
• Set the 1st Connect
Set the Profile Name:
Factory Default: 1.NEC-SETUP (2 to 9 are blank)
STEP1: Go to “Config” menu. (See “PLACE THE PHONE IN CONFIG MODE”)
STEP2: Press to view Profile Select menu.
STEP3: Press key to select a profile you want to edit and then press “OK” soft key.
STEP4: Press to go to Profile Name edit screen.
STEP5: Edit Profile Name you want and then press “OK” soft key.
STEP6: Press to save.
Prof. Select
Delete OK Back
1.NEC-SETUP
2.<Profile2>
3.<Profile3>
4.<Profile4>
Prof. Name
Office1
12 OK Clear