NEC MH240 - Set the ESSID (AP Scan)

21
Set the ESSID (AP Scan):
Factory Default: -
STEP1: Go to “Config” menu. (See “PLACE THE PHONE IN CONFIG MODE”)
STEP2: Press to view Profile Select menu.
STEP3: Press key to select a profile you want to edit and then press “OK” soft key.
STEP4: Press to scan AP and then view Scanned ESSID list.
STEP5: Press key to select ESSID you want to connect and then press “OK” soft key.
STEP6: Press to save.
Prof. Select
Delete OK Back
1.NEC-SETUP
2.<Profile2>
3.<Profile3>
4.<Profile4>
AP Scan
OK Back
wireless1
wireless2
default
hogehoge
AP Scan
AP Scanning