NEC MH240 - TO ANSWER A CALL; TO MAKE A CALL; TO TRANSFER A CALL

24
Set the Security (WPA-PSK):
Factory Default: WPA2-PSK (1.NEC-SETUP), OPEN (2 to 9)
STEP1: Go to “Config” menu. (See “PLACE THE PHONE IN CONFIG MODE”)
STEP2: Press to view Profile Select menu.
STEP3: Press key to select a profile you want to set security and then press “OK” soft key.
STEP4: Press to go to Security setting screen.
STEP5: Press key to select “WPA-PSK” and then press key.
STEP6: Press key to select an encryption “1.TKIP” or “2.AES” and then press key.
STEP7: Edit TKIP or AES Key (ASCII) and then press “OK” soft key.
STEP8: Press to save.
Prof. Select
Delete OK Back
1.NEC-SETUP
2.<Profile2>
3.<Profile3>
4.<Profile4>
Security
WPA
OPEN
WEP
WPA-PSK
WPA2-PSK
WPA-PSK
1.TKIP
2.AES
AES
abcdefghij123
12 OK Clear