NEC MH240 - Config Password Settings; Set the New Config Password; Change the Config Password

51
• CONFIG PASSWORD SETTINGS
This section explains the Config Password for the phone. The following items are covered here.
• Set the New Config Password
• Change the Config Password
Set the New Config Password:
STEP1: Press to go to New Config Password edit screen.
STEP2: Edit New Config Password (4 digits) and then press “OK” soft key.
STEP3: Press to return to Standby mode.
NOTE: This procedure is available only when MH240 has been initialized.
Change the Config Password:
STEP1: Go to “Config” menu. (See “PLACE THE PHONE IN CONFIG MODE”)
STEP2: Press to go to Old Password confirmation screen.
STEP3: Enter current Config Password and then press “OK” soft key.
STEP4: Enter New Config Password and then Press “OK” soft key.
STEP5: Press to return to Standby mode.
Password
12 OK Clear
New Password:
0000
Password
12 OK Clear
Old Password:
****
Password
12 OK Clear
New Password:
9999