NEC MH240 - Wireless Advanced Settings

52
• WIRELESS ADVANCED SETTINGS
This section explains the wireless advanced data settings for the phone. The following items are
covered here.
• Set the Channel
• Set the Data Rate
• Set the TX Power (Transmission Power)
• Set the H.O. Start
• Set the H.O. Delta
• Set the Nprobes
• Set the Scan Start
• Set the Packet Los Count
• Set the Active Time
• Set the Home Time
• Set the CAC Mode
• Set the WLC Address
To set Wireless Advanced Data, open advanced settings as follows.
STEP1: Go to “Config” menu. (See “PLACE THE PHONE IN CONFIG MODE”)
STEP2: Press to view Profile Select menu.
STEP3: Press key to select a profile you want to edit and then press “OK” soft key.
STEP4: Press to go to Advanced menu.
Prof. Select
Delete OK Back
1.NEC-SETUP
2.<Profile2>
3.<Profile3>
4.<Profile4>
Advanced
05.H.O. Delta
01.Channel
02.Data Rate
03.TX Power
04.H.O. Start