NEC NC1600C - Page 139

“Confidential, Do Not Duplicate without written authorization from NEC.”
5-9
SERVICE MODE
2 Entry Exit selection
Establishment of Bulb Entry and editing of existing Entries are carried out.
A maximum of 16 entries can be registered.
Bulb Entry cannot be deleted. If deletion is needed, it should be carried out from the touch panel or PC
control.
a) Entry Edit
• For existing Entry
Select an objective entry being edited and edit the required items.
Example of display
New Bulb
Entry Edit
(*)
[ Entry Name ]
First line : Indication of "New Bulb"
Second line : Indication of "Entry Edit"
Third line : Indication of current setup
Fourth line : Indication of Entry Name already registered
• For new establishment
Select a new Entry and enter the required input items.
When all input entry is finished, move to a higher hierarchical level of the menu.
When returning to a higher menu, a screen for entering the Entry Name is displayed. Then, enter the Entry
Name.
Example of display
New Bulb
Entry Edit
[ Entry Entry ]
First line : Indication of "New Bulb"
Second line : Indication of "Entry Edit"
Third line : Void
Fourth line : Indication of "New Entry"
New Bulb
New Entry
[ ]
First line : Indication of "Entry Edit"
Second line : Indication of "New Entry"
Third line : Void
Fourth line : Indication of Entry Name
* Enter Entry Name and make final definition with the Enter key.
If returned without entering the required input items, an alarming popup message is displayed and
a lower menu is recovered again.
Cancel New Entry with the Cancel key and return to the upper menu.