NEC NP-PH3501QL - Turning off the Projector

85
4. Projector Adjustment and Connecting
4-6. Turning off the Projector
To turn off the projector:
1. First, press the (POWER) button on the projector
cabinet or the POWER OFF button on the remote control.
The [POWER OFF / ARE YOU SURE ?] message will ap-
pear.
2. Secondly, press the ENTER button or press the
(POWER) or the POWER OFF button again.
 WhentheprojectorisinSTANDBYMODE,thePOWER
indicator lights up orange.
• Before the POWER indicator lights up orange, the
buzzer sound is released when [NOTIFICATION SET-
TING]for[BUZZER]isON.
Power On
Steady green light
Standby
Steady orenge light
Press twice
3. After the projector enters the standby state, turn off the projector power switch ([1]), then the light power
switch ([2]).
The POWER indicator will go off and the main power will turn off.
• WhilethePOWERindicatorisblinkinggreeninshortcycles,thepowercannotbeturnedoff.
ON
ON
OFF
OFF
Light power switch
Projector power switch
4. Return the administrator switch to the OFF position, then remove the administrator key.
Administrator switch
Administrator key
5. Turn off the AC power to the projector.