NEC NP-PH3501QL - Attaching the Power Cable Stopper

36
1. Before Setting Up Your Projector
Attaching the power cable stopper
To prevent the power cable from accidently removing from the AC IN of the projector, attach the supplied power cable
stopper to clamp the power cable.
CAUTION
• To prevent the power cable from coming loose, make sure that all the prongs of the power cable are fully inserted
into the AC IN terminal of the projector before using the power cable stopper to x the power cable. A loose
contact of the power cable may cause a re or electric shock.
• Do not bundle the power cable. Doing this could cause heat or a re.
NOTE
•
 Donotclampthepowercablewithothercables.Doingsocangeneratenoise,whichcanaffectadverselythesignalcable.
• Becarefulnottoinsertthebandinversely.Oncethebandisattached,itcannotberemovedfromtheslot.
1. Set the clamper band to the power cable side, and
insert the end of band of the power cable stopper into
the slot next to the AC IN on the terminal panel.
Attach the power cable stopper to the other side in the
same way.
2. Pass each band through the slits in the power cable
stopper.
Pass the bands through them so that the power cable will
be sandwiched from above and below.
Band
3. Slide the clamper to the hilt of the power cable.
Pulling the knob in the arrow direction allows you to adjust
the clamper position.
Once the clamper position is adjusted,releasetheknob
to lock the clamper.
Knob