NEC NP-PH3501QL - Connecting the Computer to the Projector and Starting up the DCC

54
2. Configuring the projector’s initial settings
2-2-3. Connecting the computer to the projector and starting up the DCC
1. Connect the computer on which the DCC is installed to the LAN port on the projector using a commercially
available LAN cable.
NOTE
• TheDCCcannotbeconnectedtotheHDBaseTport.
2. Set the projector to the standby mode.
Follow the instructions at “4-2. Turning on the Projector” (→ page 70) and set the projector to the standby mode.
3. Start up the DCC.
 FromtheWindows[Start]menu,select[AllPrograms]→ [Projector User Supportware] → [DCC].
The DCC starts up.
TIP:
•
Ifthe“LanguageSelect”screenappears,selectthedisplaylanguage.

• Tochangethedisplaylanguage,click“Option”-“Language”fromthetoolbar.

• IfaChinesefontorJapanesefontisnotinstalledonyourPC,thendisplayingChineseorJapaneseisnotsupportedandthe[
中文]buttonor[日本語]buttonisnotdisplayed.
• DCCsupports“English”,“Chinese(Simplied)”,and“Japanese”fordisplay.