NEC NP-PH3501QL - Installing the LV Unit

59
2. Configuring the projector’s initial settings
2-3. Installing the LV unit
Mount the LV unit on the projector unit.
NOTE:
• Theprojectorcannotbeusedalone.BesuretomounttheLVunitbeforeusingtheprojector.
• Beforemounting,besuretoturnofftheprojector’spower,disconnecttheACpowerandunplugthepowercord.
Preparation:
• Prepare a Phillips screwdriver.
• Remove the side panel. (→ page 17)
1. Remove slot blocking panel A.
(1)
Loosen the blocking panel A screws (2) until they turn freely.
The screws do not come off.
Blocking panel A
(2) Remove blocking panel A.
2. Remove slot blocking panel B.
(1)
Loosen the blocking panel B screws
(3) located inside the slot until they turn
freely.
The screws do not come off.
Blocking panel B
Blocking panel B