NEC NP-PH3501QL - Selecting the Power Cable for C2 Connection (English)

18
1. Before Setting Up Your Projector
1-6. Selecting the Power Cable for C2 Connection (English)
The power cable for C2 Connection is not included with the projector. Refer to “AC Power Work Specications” (next
page) and provide the necessary power cable.
WARNING
Carefully read the contents described in this section before connection and connect the cables according to the
proper procedure. Inappropriate handling may cause fatal, serious or other bodily injuries due to re or electric shock.
CAUTION
• Beforeconnectingthepowercables,checkthatthemainpowerswitchoftheprojectoristurnedoff.Implement
the connection with AC power shut off.
• Besuretogroundtheequipmenttoensuresafety.Useapowercablethatmeetsthestandardsandpowersup-
ply voltage of the country where you are using the projector (→ page 19), and always connect the equipment to
the ground. If the ground is not connected, it may cause electrical shocks.
• WhenconnectingthepowercableplugstotheACINandtheelectricaloutlet,securelyinserttheplugsalltheway
in. If the connection between the power cable plug and the electrical outlet is loose, the plug area may generate
heat, causing burns and accidents.
• Inordertopreventthepowerplugfrombeingdisconnectedfromtheprojector,xthepowercablebyusingthe
power cable stopper supplied with this unit. For how to use the power cable stopper, refer to “Attaching the
power cable stopper” (→ page 36)
NOTE:
• InstalltheelectricoutletnearbytheprojectormainunitsothatthepowersupplycanbecutbyunpluggingtheACpowercable.
• WhenplugginginorunpluggingtheACpowercable,makesurethatthemainpowerswitchispushedtothe[O]position.Failure
todosomaycausedamagetotheprojector.
• Donotuseathree-phasepowersupply.Doingsomaycausemalfunction.