NEC NP-PH3501QL - 2 Configuring the Projectors Initial Settings; Initial Settings Flow; Updating the Software; Update Flow

52
This chapter describes the preparations necessary for using the projector for the rst time.
2-1. Initial settings flow
Step 1
• Updatingthesoftware(thispage)
Step 2
• InstallingtheLVunitontheprojector(→ page 59)
Step 3
• Attachingthecontrols/indicatorpaneldisplaylabeltotheprojector(→ page 61)
NOTE:
• BesuretoupdatethesoftwarebeforemountingtheLVunit.UpdatingthesoftwareaftermountingtheLVunitcancauseanupdate
failure.
2-2. Updating the software
2-2-1. Update flow
Step 1
• InstallingtheDCConthecomputer(→ page 53)
Step 2
• ConnectingthecomputertotheprojectorandstartinguptheDCC(→ page 54)
Step 3
• Updatingtheprojector(→ page 56)
Step 4
• ExitingtheDCC(→ page 58)
2. Configuring the projector’s initial settings