NEC NP-PH3501QL - Resetting the Air Filter Usage Time

97
6. Maintenance
7. Fix the filter inside the projector unit.
(1) Snap the filter cover tabs into the cutout portion of the
projector unit to secure it.
(2) Seat the air filter aligned with the air inlet.
1
2
Cut out portion
8. Attach the front filter cover.
Push the front filter cover in the direction of the arrow to
install.
Cut out portion
9. Clean the other intake vent air filters in the same way.
Clean the other intake vent air filters in the same way as in steps (2) to (7).
NOTE
•
Beforeturningonthepower,makesurethatallltercoversareinplace.Iftheyarenotttedproperlydustcouldgetinside
theprojectorcausingittomalfunction.
•
Resetairlterusagetimeaftercleaningthelters.
6-3-2. Resetting the Air Filter Usage Time
1. Turn on the power to the projector.
2. Select [SETUP] → [RESET] and perform [CLEAR FILTER HOURS].
This completes resetting the air lter usage time.