NEC NP-PH3501QL - Ac Power Work Specifications

19
1. Before Setting Up Your Projector
AC Power Work Specications
AC power supply equipment
Do not use any voltage other than those shown below for the AC power supply connected to the projector.
200–240VAC,singlephase,power,50/60Hz
AC power supply cable for the projector
The projector is equipped with an IEC60320-C14 inlet to connect an AC power supply cable. Use an IEC60320-C13
compliant AC power cable connector and ensure that the connector meets the following current capacity specications.
Power supply voltage Projector input current Power cable current capacity
AC200–240V 4.9A 10A or higher
Furthermore, use plugs, cables, and connectors that are suitable for the regulations of the country of installation, as
shown in the following table.
NOTE:
• ForusersinNorthAmerica
 Useapowercablenolongerthan4.5m/14.76ftaccordingtoNationalElectricalCode.
• ForUKonly:InUK,aBSapprovedpowercablewithmouldedplughasablack(10Amps)fuseinstalledforusewiththisequip-
ment.Ifapowercableisnotsuppliedwiththisequipment,pleasecontactyoursupplier.
Cable
Plug
Connector
Germany
Plug Cable Connector
CEE 7
H05VV-F 3 x 1 mm
2
IEC60320 C13
USA
Plug Cable Connector
NEMA 6-15P
SJT 3 x AWG 16 IEC60320 C13