NEC NP-PH3501QL - Exiting the DCC

58
2. Configuring the projector’s initial settings
7. Check that all of the results are “OK”.
If Different is displayed
Return to step 1 and execute the update again.
NOTE
• When,afterhavingmountedtheLVunit,updatingtheprojectorforthepurposeofversionupgrade,insteadoftheprojector’s
initialsettings,settheprojector’sIPaddresstoaconnectiondestination,andexecutefromstep1throughstep7.
 Theprojector’sIPaddresscanbecheckedonthesettingofWIREDLANfromtheonscreenmenu.
• TheupdateforthepurposeoftheinitialsettingsmustbedonebeforemountingtheLVunit.
2-2-5. Exiting the DCC
1. Click “File”.
The [File] menu will appear.
2. Click “Exit”.
The DCC will close.
3. Turning off the Projector
Follow the procedure at “4-6 Turning off the Projector” (→ page 85)toturnofftheprojector’spower,thendiscon-
nect the AC power.
TIP:
•
Tochecktheprojector’sinformationandlogusingtheDCC,see“7-8.UsingtheDCC’sfunctions”(→page118).