NEC NP-PH3501QL - Installing the DCC on the Computer

53
2. Configuring the projector’s initial settings
2-2-2. Installing the DCC on the computer
Overview of DCC
DCC is software for controlling and managing projectors via the network. A maximum of 20 units can be congured and
managed from a computer by connecting to the projectors via the network from a computer where DCC is installed.
TIP:
• DCCsupports“English”,“Chinese(Simplied)”,and“Japanese”fordisplay.
Supported devices
Contact your distributor for information about which devices are supported by DCC.
Operating environment of DCC
This software can be used with the personal computer that lls the following environments.
SupportedOS Microsoft Windows 7/8/8.1/10 (32-bit or 64-bit)
Microsoft Windows Server 2008/2012
LAN environment Except for supported host names of standard TCP/IP, a xed IP address is required
for most devices that are directly connected to a LAN.
HDD capacity 70 MB
(Note)
or more is required for installation.
(Note): Necessary capacity can vary by updating the DCC.
Installing the DCC
This section describes the installation procedure of DCC. Use the same procedure as for installation for version
upgrading (installation by overwriting).
Preparatory operation:
• BootupyourPC’sWindows.
• IfyouhavealreadystartedWindows,quitallrunningapplicationprograms.
If you do not quit all running programs before installing the DCC Software, you risk having unsuccessful installation.
NOTE
• Abouttheprivilegesusedduringsoftwareinstallationanduninstallation
- ForWindows8/Windows10
 Performasauserwhohas“Administrator”selectedastheaccounttype.
• OnWindows7,ifthe“UserAccountControl”windowisdisplayed,click“Allow”.OnWindows8/Windows10,click“Yes”.
1. Save the EXE file of the DCC in the local drive of the personal computer.
2. Double-click the EXE file that was saved.
The installer starts.
3. Install the DCC (version upgrading) according to the instruction of the installer.
DCC has now been installed (the version has been upgraded).
DCC uninstalling
Uninstall the Software from the menu shown below.
• ForWindows10
Right-click [Start] → [Control Panel] → [Uninstall a program]
• ForWindows8
Hold down the [Windows] key and press the [X] key → [Control Panel] → [Uninstall a program]
• ForWindows7
[Start] → [Control Panel] → [Programs] → [Programs and Features]