NEC NP-PH3501QL - Indicator Messages

100
7. Appendix
7-2. Indicator Messages
This section helps you resolve problems you may encounter while setting up or using the projector.
POWER Indicator
Indicator display Projector status Procedure
Off Power is off. –
Flashing Green (short ashes) Preparing to power up or cooling the main
unit
When the projector is in the standby state,
the rmware is ready to be updated
Wait a while.
Green (twice per cycle) Firmware is ready to be updated –
Green (long ashes)
Offtimer(enabled)
Program timer (off time enabled)
–
Orange(longashes) Program timer (on time enabled) –
Lit Green Power on –
Orange Standby mode –
STATUS Indicator
Indicator display Projector status Procedure
Off No problem –
Flashing Green (short
ashes)
Shutter is closed –
Green (long
ashes)
Power on (The light mod-
ule is turned off.)
–
Orange Button has been pressed
while projector is in key
lock mode
The projector’s keys are locked. The setting must be can-
celed to operate the projector.
Projector’s ID number
and remote control’s ID
number do not match
Check the control IDs.
Projector cooling Wait a while.
Red Error occurring Contact your distributor or service personnel. Let us know
the details displayed on the liquid crystal indicator panel
then.
Lit Green Power on –
Orange Standby mode –
Red Error requiring service
support
Ask your distributor or service personnel for repair. Let us
know the details displayed on the liquid crystal indicator
panel then.