NEC NP-PH3501QL - Procedure for Connecting the Power Cable (C1 Connection)

31
1. Before Setting Up Your Projector
1-8-2. Procedure for connecting the power cable (C1 connection)
Preparation:
Phillips-head screwdriver (No. 2), service key (projector accessory)
WARNING
• Beforeconnectingthepowercable,makesurethattheACpowersupplyisdisconnected.Otherwiseareor
electric shock may occur.
• Highleakagecurrentows.DoNOTconnectthepowersupplybeforegroundingconnection.
1. Remove the plate inlet.
Remove the plate inlet by loosening the fixing screws (at six points).
 InEurope,replaceitwiththesupplied⌀35 plate inlet.
Plate Inlet
2. Pass the power cable through the cable hole of the plate.
If you use the supplied ⌀35plateinlet,passthepowercablethroughacommerciallyavailablecablestopper
and then insert it into the cable hole.
Cable stopper