NEC NP-PH3501QL - Page 83

57
2. Configuring the projector’s initial settings
2. Click the “Full-Auto” button.
3. Select the “nprelease” file stored on the local drive, then click the “Open” button.
A progress bar is displayed and the update begins. The update proceeds automatically.
NOTE
• Duringupdating,theprojectorturnsonautomatically.Afterthat,theprojectorautomaticallyreturnstothestandbystate.
4. Check the results of the update.
 If“Error”isnotdisplayedonthescreenbottomofcolumn,theupdatehascompletedsuccessfully.
 Oncetheupdateiscompleted,amessagesuchasthefollowingappearsbelowthescreen.
If the update is successful: Update Success
If the update is unsuccessful: Update has failed
5. Once the update is successful, click the “Exit” button.
The All Update screen closes.
6. Click the “Update End” button.