NEC NP-PH3501QL - Page 81

55
2. Configuring the projector’s initial settings
4. Setting a connection destination
 WhentheDCCisactivated,theProjectorSelectscreenisdisplayed.ThisscreenisusedtosettheIPaddressor
host name of the connection destination device. The connection destination devices that have been connected
toaresavedinahistory,andtheconnectiondestinationcanbeselectedfromthishistory.Thisscreencanbe
displayed also by selecting “Select Projector... ” from the tool bar.
Multiple connection Allows to set multiple connection destination devices.
Without check: Set only 1 connection destination device.
With check: Set multiple connection destination devices. When mul-
tiple destination devices are set, the currently connected device is
located at the top of the connection list.
Enter the network setting of the connection destination device. Select
the IP address or the host name and enter the necessary items.
IP Address/Host Enter the IP address.
• Whenentering an addressfrom the connectionhistory, double-
click the IP address/Host eld, then select the connection history
displayed.
 Valuesetatfactoryshipment:192.168.10.10
Projector Name Displays the host name of the connection destination device.
“Add” button Adds a connection destination device.
“Edit” button Sets the connection destination device.
“Delete” button Deletes the connection destination device.
“History” button Edits (or deletes) the information history of the connection destina-
tion device.
Check that the IP address is set to the factory default of “192.168.10.10”, then click the [OK] button.