37
1. Before Setting Up Your Projector
4. Pull the band to hold the power cable.
Pulling the knob in the arrow direction allows you to adjust
the band position.
Pull the top and bottom bands by keeping their balance.
Once the band position is adjusted,releasetheknob to
lock.
Knob
Knob
This completes the attachment of the power cable stopper.
Removing the power cable from the power cable stopper
1. Pull the knob of the clamper and loosen the band.
2. Pull the knob and slide the clamper away from the
power plug.
CAUTION
• The projector may become hot temporarily when the power is turned off or if the AC power is disconnected while
the projector is projecting. Take care when handling the projector.
To Next Page
Loading...
