29
1. Before Setting Up Your Projector
Connecting the cable
In order to attach the power cable to the connector block, connect the wires using the following procedure such that
the individual wires cannot directly touch each other.
1. Remove the power cable sleeves from the terminals to
ensure that the sleeves are not pinched by the terminal
attachment screw.
Pull back the sleeves from the terminal area before fastening
the screw to prevent the sleeves from being pinched.
Sleeves
2. Attach the sleeves after tightening the screw.
Tighten the fixing screw to the designated torque.
Use sleeves and secure the insulation to ensure that terminals
do not touch each other. If the cables are attached to the
powersupplyterminalwithoutusingsleeves,thereisariskof
the terminals touching each other as shown in the photograph
on the right.
To Next Page
Loading...
