NEC NP-PH3501QL - Page 59

33
1. Before Setting Up Your Projector
7. Remove the fixing screws (at two points), eject the fixing bracket in the direction of the arrow, and pull out
the power connector.
8. Configure the power supply for C1 connection.
 ForC1connection,connecttheinner-sideconnector.
Connect
Connect
9. Return the power connector and the fixing bracket to their original position, and fix the fixing screws (at
two points).
10 . Fix the plate inlet with the fixing screws (at six points).
 InEurope,fixthesupplied⌀35 plate inlet.