UNIVERGE SV8100 Issue 1.0
SV8100 Features and Specifications Manual 2 - 987
35-02-15 SMDR Output Options – CLI/DID
Number Switching
Enter 0 to display the Caller ID
number. Determine if the Caller ID
number (0), DID number (1) or
Caller ID name (2) should be
displayed in the SMDR output.
0 = CLI (CLIP)
1 = DID Calling Number
(default = 0)
3
35-02-16 SMDR Output Options – Trunk
Name or Received Dialed Number
Determine how the SMDR should
print incoming calls on ANI/DNIS or
DID trunks. If set to (1), ANI/DNIS
trunks can print DNIS digits. For DID
trunks, if the received number is not
defined in Program 22-11-01, a
number is not printed. If set to (0)
trunk names are printed instead (as
assigned in Program 14-01-01).
0 = Trunk Port Name
1 = Received Dialed
Number
(default = 0)
3
35-02-17 SMDR Output Options – Print
Account Code or Caller Name of
Incoming Call
Determine whether the Account
Code (0) or Caller ID name (1)
should appear in the SMDR record.
By default, the Account Code is
displayed.
Program 35-01-08 must be set
to 0 for this entry to be
followed.
0 = ACC
1 = CNAME
(default = 0)
3
35-02-18 SMDR Output Options – Print
Mode for Caller Name of Incoming
Call
Select whether to display up to 16
characters of the Caller Name on
the same line as the call record (0)
or if a line feed should be added and
up to 24 characters of the Caller
Name will be displayed on the
following line (1). If the line feed
option is selected, the Caller Name
is displayed on the next line as :
NEXT Caller Name. The default
entry for this option is 0.
This setting works regardless of the
setting in Program 35-02-15.
With this option set to 1, if your
communications program
(such as HyperTerminal) has
the line wrap option enabled in
the ASCII setup, an additional
line break may appear above
the Caller name line.
0 = Normal
1 = Line Feed
(default = 0)
3
35-03-01 SMDR Port Assignment for Trunk
Group
Assign the SMDR port for each
trunk group. For each Trunk Group,
select the SMDR port to which the
incoming SMDR information should
be sent.
Trunk Groups: 1~100
SMDR Ports: 1~8
(default = 1)
3
35-04-01 SMDR Port Assignment for
Department Groups
Assign the SMDR port for each
Department Group. For each
Department Group, select the
SMDR port to which the outgoing
SMDR information should be sent.
Department Groups: 1~64
SMDR Ports: 1~8
(default = 1)
3
Program
Number
Program Name Description/Comments Assigned Data
Level
1 2 3
To Next Page
Loading...
