NEC Univerge SV8100 - Page 1058

Issue 1.0 UNIVERGE SV8100
2 - 1034 SV8100 NetLink
51-04-01 IP Address Setting of Top Priority
Primary System of Net-Link –
Internet Protocol Address of Top
Priority Primary
Enter the IP address of the Top
Priority Primary System.
To use this feature, set Program 51-
06-01 to 1(On).
0.0.0.0 ~
126.255.255.254
128.0.0.1 ~
191.255.255.254
192.0.0.1 ~
223.255.255.254
(default = 0.0.0.0)
3
51-05-01 Net-Link Timer Settings – Keep
Alive Sending Interval
This is the Keep Alive timer sending
interval from the Secondary system
to confirm communication with the
Primary system.
1~3600
(default = 5)
3
51-05-02 Net-Link Timer Settings – Keep
Alive Response Waiting Time
This is the time interval the
Secondary system waits for a
response from the Primary system
before cutting off communication.
0, 3~10800
(0 = infinity)
(default = 20)
3
51-05-03 Net-Link Timer Settings – Primary
Search Packet Sending Interval
While searching the Primary system,
the system sends a packet at this
interval.
1~3600
(default = 5)
3
51-05-04 Net-Link Timer Settings – Primary
Search Time Maximum Value
Total time of Primary system seek
time.
5~10800
(default = 20)
3
51-05-05 Net-Link Timer Settings – Top
Priority Primary Detection Packet
Sending Interval
When current Primary system is not
Top Priority Primary System, the
system sends packet to check if Top
Priority System exists.
1~3600
(default = 10)
3
51-05-06 Net-Link Timer Settings – Primary
Compulsion Specification Trial
Maximum Time
When the forced change Primary
command is executed, the system
will search the new Primary system
for this amount of time.
1~10800
(default = 30)
3
51-05-07 Net-Link Timer Settings – Socket
Refresh Time
For some reason, the IP connection
may become unstable. Then keep-
alive function does not work. To
avoid this, if there is no data traffic
for this time, the socket is refreshed.
20~3600
(default = 40)
3
51-06-01 Net-Link Primary Automatic
Integration Setting – Primary
Integration Right or Wrong
When LAN cable was divided,
multiple Primary systems may
appear. If the LAN connection is
recovered, multiple Net-Links exist
in the network. When this option is
enabling, Net-Link will be composed
around Top priority Primary System.
0 = Off
1 = On
(default = 0)
3
51-06-02 Net-Link Primary Automatic
Integration Setting – Package
Reset Timing Option
When Primary System Automatic
Integration is done, all packages of
secondary systems will reset. This
option can select the timing of
package reset.
0 = Reset when all
packages are in idle
condition
1 = Anytime
(default = 0)
3
51-07-01 Net-Link Primary Compulsion
Specification Setting – Forced
Change Primary System Enabling
Set this item whether the Forced
Change Primary is available or not.
0 = Disable
1 = Enable
(default = 1)
3
Program
Number
Program Name Description/Comments Assigned Data
Level
1 2 3