NEC Univerge SV8100 - Page 1101

UNIVERGE SV8100 Issue 1.0
SV8100 Features and Specifications Manual 2 - 1077
34-09-06 ANI/DNIS Service Options –
Routing SPD Table Setup
Use this option to define which part
of the SPD Dial Table set up in
Program 13-04 the system uses for
ANI/DNIS Caller ID look-ups and
ANI/DNIS routing (Start = 0,
100~1900, End = 0, 99~1999).
This is required if Items 4 and 5
above are 1 (Caller ID on). When
you specify a starting and end
address, the system uses the part
of the table for look-ups. When you
specify a starting address and
length, the system uses that part of
the table for routing. If the incoming
ANI/DNIS number data matches
the Number entry in the table, the
system routes according to the
associated Name data. That data
can be an extension, Department
Group pilot number, the voice mail
master number or a trunk ring
group.
Start=0, 100~1900
End= 0, 99~1999
Default:
COS 1~14
Start = 1000
End = 1199
COS 15
Start = 0
End = 0
3
34-09-07 ANI/DNIS Service Options –
Routing on ANI/DNIS Error
This option lets you determine how
the system handles an ANI/DNIS
call if a data error is detected in the
incoming data string (0 = Play busy
tone to caller, 1 = Route the caller
to the ring group specified in
Program 25-03).
0 = Play Busy Tone to
Caller
1 = Route Caller to Ring
Group Specified in
Program 25-03 (Transfer)
(default = 1 for
COS 1~14
default = 0 for COS 15)
3
34-09-08 ANI/DNIS Service Options –
Routing When Destination Busy
or No Answer
This option lets you determine how
the system handles an ANI/DNIS
call if destination is busy or does
not answer (0 = Play busy or
ringback tone to caller, 1 = Route
the caller to the ring group
specified in Program 25-04).
0 = Play Busy or
Ringback Tone to Caller
(Busy/ NoAns)
1 = Route Caller to Ring
Group Specified in
Program 25-04 (Transfer)
(default = 0 for
COS 1~15)
3
34-09-09 ANI/DNIS Service Options –
Calling Number Address Length
When Item 1=0 (ANI/DNIS receive
format is address), use this option
to specify the address length. The
choices are 1~8 digits.
1~8
(default = 7 for
COS 1~15)
3
34-10-01 Digits Delete for T1 ANI
Assignment
This option defines the number of
digits to delete from the information
element received from Telco.
0~9
(default = 2)
3
Program
Number
Program Name Description/Comments Assigned Data
Level
1 2 3