NEC Univerge SV8100 - Page 1114

Issue 1.0 UNIVERGE SV8100
2 - 1090 Tandem Trunking (Unsupervised Conference)
Method D – Tandem Trunking to Speed Dial Number
20-11-14 Class of Service Options (Hold/
Transfer Service) –
Trunk-to-Trunk Transfer
Restriction
Turns Off (0) or On (1) the Trunk-to-
Trunk Transfer Restriction. If
enabled, Trunk-to-Trunk Transfer is
not possible.
0 = Off
1 = On
(default = 0 for
COS 1~15)
3
20-11-21 Class of Service Options (Hold/
Transfer Service) – Restriction for
Tandem Trunking on Hang Up
Allow (0) an extension user’s ability
to set up a tandem call
automatically when they hang up.
0 = Off
1 = On
(default = 0 for
COS 1~15)
3
24-02-07 System Options for Transfer –
Trunk-to-Trunk Transfer Release
Warning Tone
This timer starts when a trunk
begins talking with another trunk
(for example: Trunk-to-Trunk
Transfer, outgoing from trunk,
Tandem Trunking) (0~64800
seconds).
0~64800 (seconds)
(default = 1800
seconds)
3
24-02-10 System Options for Transfer –
Disconnect Trunk-to-Trunk
This timer starts after the
Trunk-to-Trunk warning tone is
heard (0~64800 seconds).
0~64800 (seconds)
(default = 0 seconds)
3
25-07-07 System Timers for VRS/DISA –
Long Conversation Warning Tone
Time
Determine the time a DISA caller or
any trunk-to-trunk (such as Tandem
Trunking) conversation can talk
before the Long Conversation tone
is heard (0~64800 seconds).
0~64800 (seconds)
(default = 1800
seconds)
3
25-07-08 System Timers for VRS/DISA –
Long Conversation Disconnect
Time
Determine the time the system
waits before disconnecting a DISA
or any trunk-to-trunk (such as
Tandem Trunking) call after the
Long Conversation tone is heard
(0~64800 seconds).
0~64800 (seconds)
(default = 30 seconds)
3
Program
Number
Program Name Description/Comments Assigned Data
Level
1 2 3
11-10-06 Service Code Setup (for System
Administrator) – Setting the
Automatic Transfer for Each
Trunk Line
If the default service code (733) for
enabling Automatic Tandem
Trunking feature is not acceptable,
change the code as required.
MLT
(default = 733)
3
11-10-07 Service Code Setup (for System
Administrator) – Canceling the
Automatic Transfer for Each
Trunk Line
If the default service code (734) for
canceling Automatic Tandem
Trunking feature is not acceptable,
change the code as required.
MLT
(default = 734)
3
11-10-08 Service Code Setup (for System
Administrator) – Setting the
Destination for Automatic Trunk
Transfer
If the default service code (735) for
setting the destination of the
Automatic Tandem Trunking feature
is not acceptable, change the code
as required.
MLT
(default = 735)
3
Program
Number
Program Name Description/Comments Assigned Data
Level
1 2 3