UNIVERGE SV8100 Issue 1.0
SV8100 Features and Specifications Manual 2 - 1089
Method C – Tandem Trunking on Hang up
24-02-10 System Options for Transfer –
Disconnect Trunk-to-Trunk
This timer starts after the
Trunk-to-Trunk warning tone is
heard.
0~64800 (seconds)
(default = 0 seconds)
3
25-07-07 System Timers for VRS/DISA –
Long Conversation Warning Tone
Time
Determine the time a DISA caller or
any trunk-to-trunk (such as Tandem
Trunking) conversation can talk
before the Long Conversation tone
is heard.
0~64800 (seconds)
(default = 1800
seconds)
3
25-07-08 System Timers for VRS/DISA –
Long Conversation Disconnect
Time
Determine the time the system
waits before disconnecting a DISA
or any trunk-to-trunk (such as
Tandem Trunking) call after the
Long Conversation tone is heard.
0~64800 (seconds)
(default = 30 seconds)
3
Program
Number
Program Name Description/Comments Assigned Data
Level
1 2 3
14-01-04 Basic Trunk Data Setup –
Transmit Gain Level for
Conference and Transfer Calls
Select the Transmit CODEC gain
level used by the trunk when it is
part of an Unsupervised
Conference.
1~63(-15.5dB ~
+15.5dB in 0.5dB
intervals)
[default = 32 (0dB)]
3
14-01-05 Basic Trunk Data Setup – Receive
Gain Level for Conference and
Transfer Calls
Select the Receive CODEC gain
level used by the trunk when it is
part of an Unsupervised
Conference.
1~63(-15.5dB ~
+15.5dB in 0.5dB
intervals)
[default = 32 (0dB)]
3
14-01-13 Basic Trunk Data Setup –
Trunk-to-Trunk Transfer
For each trunk, enter 1 to enable
loop supervision.
0 = Disable
1 = Enable
(default = 1)
3
20-06-01 Class of Service for Extensions Assign a Class of Service (1~15) to
an extension.
Day Night/Mode: 1~8
Class of Service of
Extensions (1~15)
Default:
Extension port 101 =
Class 15
All other extension port
= Class 1
3
20-07-11 Class of Service Options
(Administrator Level) – Forced
Trunk Disconnect (analog trunk
only)
Turns Off (0) or On (1) an extension
to use Forced Trunk Disconnect.
This allows the extension to
disconnect an Unsupervised
Conference in progress.
0 = Off
1 = On
(default = 0 for
COS 1~14)
(default = 1 for
COS 15)
3
20-11-11 Class of Service Options (Hold/
Transfer Service) – Automatic On-
Hook Transfer
Turns Off (0) or On (1) the Trunk-to-
Trunk Transfer Restriction. If
enabled, Trunk-to-Trunk Transfer is
not possible.
0 = Off
1 = On
(default = 0 for
COS 1~15)
3
Program
Number
Program Name Description/Comments Assigned Data
Level
1 2 3
To Next Page
Loading...
